Skip to content
Not enough clearance for full camber adjustment
Spacers
Interference
Bolt removed even with spacer – reduced size and/or mod required
WIthout spacer this contacts seat bottom
PASSENGER SIDE Hard contact without spacer – crossbar could not be installed.
Seat interference- note that entire assembly is on rubber (deformable) mounts so at least 1/4-1/2″ clearance is needed to aviod contact
interference
Spacer – note that 4 washers (6mm) of standard diammeter are inside bushing. A special stepped spacer should be machined.
You must be logged in to post a comment.